Side Cutter for hard wire, ◯ Max. Ø 1,0mm / .040” , 15cm,TC 4628

ErgoDenta ApS · #4628

Collecté automatiquement depuis ergodenta.dk

Vous êtes le fabricant ?Transmettez vos données

Texte du fabricant en anglais

The Side Cutter for hard wire, ◯ Max. Ø 1,0mm / .040” , 15cm,TC is an orthodontic cutter for cleanly cutting and trimming wires and ligatures.

  • Sharp, hardened blades cut wire cleanly
  • Flush-cut tips for patient comfort
  • Reusable and fully autoclavable

Reprocessing Instructions

Important: ErgoDenta instruments are supplied NON-STERILE and must be cleaned, disinfected, and sterilized before first use and after each subsequent use. Step 1 – Pre-Cleaning: Rinse under cold running water immediately after use. Remove visible debris with a soft brush. Keep instruments moist until processing. Step 2 – Automated Cleaning: Washer-disinfector: pre-rinse cold, enzymatic wash 55°C/10 min, thermal disinfect 90°C/5 min, dry. Step 3 – Inspect & Maintain: Check for residual soil, corrosion, or damage. Lubricate hinged instruments with medical-grade lubricant. Step 4 – Package: Place in ISO 11607-compliant sterilization pouches or wraps. Arrange to prevent tip contact. Seal properly. Step 5 – Sterilize: Autoclave at 134°C (273°F) for min. 18 minutes, pre-vacuum cycle. Validate with chemical and biological indicators. Step 6 – Store: Store in a clean, dry, enclosed area. Verify packaging integrity before use. Re-sterilize if compromised.

Informations produit

FabricantErgoDenta ApS
TypeOrthodontic cutter
Longueur15 cm
MatériauTC
StérilisationEntièrement autoclavable